LOW PROFILE
One layer under the case keeps the watch closer to your wrist.
RDX / MISSION STRAPS
One watch. Different demands. Pair purpose-built straps for the way you move, from the trail to everyday wear.




Mix eligible titanium-hardware Mission Straps. Savings apply automatically at checkout. No code needed.
One continuous layer keeps your watch captured if a spring bar fails — while sitting lower, cleaner and closer to the wrist than a traditional G10.
NO LOOSE ENDS.
Loose strap tails flap, snag and bunch. Our solid titanium keepers have enough clearance to double the excess strap back underneath the final loop — tucking the tail flat and helping it stay in place through daily wear.
Same solid titanium keeper design across G10, Single Pass and Two Piece.
One layer under the case keeps the watch closer to your wrist.
If one spring bar fails, the strap still captures the watch.
Slide it through. No tools. Swap your setup in seconds.
Your strap should be the last thing on your mind once the day gets moving. That's why we care about the details most people overlook — how it sits, how the tail stays put, and how easily it goes back into service.
Not more gear to think about. Better gear for getting on with what matters.
Generic straps often hang expensive watches from stamped hardware and tiny buckle spring bars. REDUX buckles are machined from solid titanium, then bead-blasted for a low-glare finish.
Dense ballistic nylon gives you durability without turning the strap into a stiff plank. It flexes, dries quickly, cleans easily and can be trimmed and heat-sealed to tune the tail length.
Choose by how you want the watch to sit and how much retention you want.
Traditional mounting. No layer under the case. Familiar everyday fit.
VIEW TWO PIECE →One continuous layer. Faster changes. Added spring-bar failure security.
YOU'RE VIEWING THIS SETUPSecondary keeper architecture. Traditional military setup. More locked-in feel.
VIEW G10 →